User Tools

Site Tools


Sidebar


mbd_servo_drive:analog_command

Drive with analog reference

Upon request, the servo amplifier can be controlled via analog input, also it is fitted with an output “line driver” 5V type encoder emulation.
The resolution of the emulated encoder is the same as the main motor encoder. You can't set an encoder emulation with a variable number of
pulses / revolutions. Is it possible to find a comprehensive overview of the device connections in paragraph 6. The connectors to be used for driving in analog are C9: analog input; C7 encoder emulation and C5: inputs and outputs.

Analog Input

Analog-In 1 Input (terminal C9/1-4), differential analog input 12bit.
Differentials input voltage of max. ± 10 V.
Connect the controller (PLC or NC) as following indicated.

analog_1.jpg

analog_2.jpg

Example using a potentiometer

If you want to drive the servo amplifier by a potentiometer and you do not have a ± 10V dual voltage power supplies, the voltage can be derived using the following circuitry. In the first diagram is shows how to drive the motor with a voltage from 0 to 10V, in the second with a voltage from 0 to-10V.

pot_1.jpg

Encoder Emulation

With the “analog” option the connector C7 provides the emulation of the motor encoder. The C8 connector on the contrary will not mount.
The emulated encoder output is a 5V opto line-driver type. The emulated encoder resolution is fixed and it is the same as the motor main
encoder (default 2048ppr)

enc.jpg

mbd_servo_drive/analog_command.txt · Last modified: 2022/11/15 08:39 by mgavesi